The Clearwater Industries Model 50 Polymer Injection System is designed to make down dry polymers that will rapidly settle suspended solids out of wastewater. The Model 50 is a low-budget, but very effective, way to properly wet dry polymers and pump the solution either to the process or to a customer-supplied aging vessel. The Model 50 will deliver a continuous water/polymer solution ranging from 1/3 pound per hour up to 34 pounds per hour. These systems are very cost effective, and are used to:

• Rapidly flock out solids in the first settling ponds
• Convert existing liquid polymer systems to dry feed systems

Features:

• Compact unit with hopper at good height for easy loading of polymer
• Small design fits easily inside existing tool sheds or trailers
• Can be "up and running" 15 minutes after delivery
• Stainless Steel 110 lb. Hopper (200 lb. Hopper optional)
• Variable speed screw feeder with solid shaft auger
• Stainless steel wetting funnel with fully washed sides effectively wets and disperses polymer
• Progressive cavity polymer disbrsement pump. Variable speed DC motor drives pump. Maximum pump delivery is 15 gpm
• 3/4" stainless steel Static Mixer on pump discharge
• 1-1/2" square steel framework painted with Aliphatic Urethane Epoxy paint, which yields a high chemically resistant finish that fades little under UV rays

Utilities:

• One 115-volt plug supplies power to two DC motors
• One-point clean water hook-up, 3/4" line at 25 to 80 psi

Dimensions:

• Framework is 27"(W) x 45"(L) x 55"(H)
• Approximate shipping weight 200 lbs.